Beltline Molding Kit 4pc Chrome L&R | Chevy 1967-72

Four moldings. Two rear doors. Chrome bead. A beltline molding is a squeegee. It wipes the rear door glass clean going up and down and it stops the water that runs off the glass from going inside the door. When the rubber lip is gone the glass carries grit; the inner panel stays damp and the bottom of the door starts to bubble. This is the chrome bead set for both rear doors of a Suburban - inner and outer; left and right. Pre-applied clips; ozone resistant material; the original section. If the glass run channels in your rear doors are hard as well then buy the eight piece kit instead and do it once. This four piece is the right call when the channels are still soft and only the beltlines have failed. Chrome bead. The bright edge is what shows with the door open.

Install Level: Moderate

Four pieces: inner and outer beltline moldings for the left and right rear doors.
Beltline moldings only. Glass run channels are not included.
Suburban applications only.
Pre-applied clips. Replacement door clips are not included.
Prop 65 warning: Cancer and Reproductive Harm - http://www.p65warnings.ca.gov/