Black Moisture Trap / Filter w/ (2) Fittings
Compressors make air. They also make water. Every compressor pulls humid air off the street and packs it into a tank. The moisture comes out of suspension on the way down the line and arrives at your valve block as droplets. Valves do not like droplets. Neither does a cold morning. This is the trap that catches it. Black body; two fittings supplied; plumbed after the tank and before the valves so condensation that collected in the tank never reaches the manifold. That order matters more than the part does. Put it upstream of the tank and you filter the wrong air. It is the cheapest insurance in an air system. A stuck valve costs a corner of ride height and a tow home.
Install Level: Moderate
Install after the tank and before the valve manifold.
Universal air management part. No vehicle application is published.
In an air suspension system, you will have 1 or 2 air compressors that generate air to be delivered throughout your components. As with any air compressor, moisture can generate in the airlines, sending water droplets through the lines. This is not something that you want in any air system, so a moisture trap/filter should be installed. Air suspension water traps filter out moisture and debris from the air that gets passed through them. This AccuAir black moisture trap/filter and fittings kit gives you everything you need to ensure your system stays moisture free. In this kit, you will receive a black moisture trap/filter and two fittings to install the filter on your system.
Where Do You Put The Water Trap On An Air Suspension System?
The moisture trap or water trap should be located after the tank and before the valves. This allows any condensation that was located in the tank to be stopped from getting to your valves. Stopping moisture from getting to your valves is important to keeping your air suspension system functioning properly.
Type: air suspension moisture trap / filter
Finish: black
Included: one moisture trap / filter
Included: two fittings
Position: downstream of the air tank and upstream of the valve manifold
Listed price 104.95 USD
No port size; thread size; micron rating; bowl material or drain type is published on this listing
Plumbed into the 3/8 inch supply line between the air tank and the valve manifold.
No Gen: tag; year or model application is published on this listing so generations are left blank rather than guessed.
Works alongside any compressor and tank combination that runs a common supply line to the valves.
