20ft USB Harness for TouchPad
Twenty feet. Plug in. Done.
The TouchPad is the part of the system your hand touches; which means the cable behind it gets pulled; pinched; folded behind a dash panel and trapped under a seat rail more times than any other wire on the truck.
When it fails the controller goes dark or intermittent and the whole system feels broken. It is not. It is twenty feet of USB cable that finally gave up where someone closed a panel on it.
This is the direct replacement. Plug and play at both ends; installs in minutes according to Accuair; long enough to route properly rather than pulled tight across a kick panel.
Route it once; properly; and you will not meet it again.
- Twenty feet of reach - enough to route around a dash rather than across it in a straight pull.
- Plug and play - no splicing; no connector pinning; the controller works or it does not.
- The usual failure - the TouchPad cable takes more handling than any other wire in the system.
- Minutes to fit - once the trim is off the swap itself is quick.
- Keeps the controller - a dark TouchPad is usually a dead cable and the cable is the cheaper half.
Install Level: Easy
20 foot USB harness for the Accuair TouchPad+ controller.
Plug and play replacement for the factory harness. Published as installable in minutes.
Accuair Suspension
SKU: AA-3676
ISBN: 81753022
Expert Tech Support
ShopTested Parts
Worldwide Shipping
⚠️
WARNING: Handling passenger or off-highway motor vehicle parts can expose you to chemicals such as phthalates and lead.
Learn more.