Gen 4X Coyote Control Pack w/ Manual Trans
Gen 4X. The newest crate Coyote; wired without the guesswork. The M-6007-M50H is the engine people are building around now. It is also the one with the least community knowledge behind it; which means the wiring is not something to work out by trial and error at two in the morning. This is the Ford Performance pack for that engine with a manual transmission. PCM with a Gen 4X specific calibration; a control pack harness that replaces the stock body harness; and an OBD-II port for troubleshooting and code reading. The kit brings the electronic throttle pedal; power distribution module; air box; air inlet tube; upper and lower radiator hoses and HEGO sensors. No cable throttle to route; no relay board to invent. Then the honest part. A return type fuel system is required; see the instructions. This pack will not run a production F-150 or Mustang Coyote engine; and the PCM will not start any production Mustang. It exists for a custom vehicle. Competition and off-highway use only.
Install Level: Advanced - engine swap wiring; PCM calibration and full body harness replacement
Runs the M-6007-M50H 5.0L Gen 4X Coyote crate engine with a manual transmission.
Requires a return type fuel system; see the Ford Performance instructions.
NOT for use with any production F-150 or Mustang Coyote engine.
Installing the PCM in any production Mustang results in a no-start condition.
This part is designed and intended for competition use only or off-highway use only. It should not be installed on a vehicle that is driven on public roads and highways. Installation on a road-going vehicle is likely to violate U.S. and Canadian motor vehicle emissions law.
- Part Number: M-6017-M50HA
Take the complexity out of wiring your Gen 4X 5.0L Coyote crate engine with the Ford Performance Parts control pack.
- Runs the M-6007-M50H 5.0L Coyote crate engine with manual transmission
- Includes PCM with unique Ford Performance calibration
- Includes Electronic Throttle Pedal eliminating cable routing issues
- Unique control pack harness replaces stock body harness and is designed for custom vehicle installation
- OBD-II port for trouble shooting/code reading
- Includes power distribution module, air box, air inlet tube, upper and lower radiator hoses, and HEGO sensors
- Requires return type fuel system (see instructions)
Listed SKU M-6017-M50HA - see the note on part numbering
Runs the M-6007-M50H 5.0L Gen 4X Coyote crate engine
PCM with unique Ford Performance calibration
Electronic Throttle Pedal
Unique control pack harness; replaces the stock body harness
OBD-II port for troubleshooting and code reading
Power distribution module
Air box
Air inlet tube
Upper and lower radiator hoses
HEGO sensors
Requires a return type fuel system
Not for use with any production F-150 or Mustang Coyote engine
Competition use only or off-highway use only
Not for use with any production F-150 or Mustang Coyote engine.
Requires a return type fuel system.
Engine-defined part; no chassis year or model application is published.
